Can the Lactose/Galactose Assay Kit (Rapid) (K-LACGAR) be used to test solid samples using PROCEDURE B: (For “low-lactose” or “lactose-free” samples containing high levels of monosaccharides)?

Modified on Fri, 24 Sep, 2021 at 4:41 PM

Step 1: Add 1 g of sample (or homogenised sample) to 4 mL of water, mix then add 1 mL of 10 mg/mL sodium borohydride (dissolved in 50 mM NaOH and less than 5 hours old). Incubate this solution in a sealed plastic container at 40°C for 30 min then neutralise by the addition of 2.5 mL of 0.2 M acetic acid. Transfer all of the borohydride reduced sample (~ 8.5 mL) to a 10 mL volumetric flask and make the final volume to 10 mL with distilled water. Filter through Whatman No. 1 filter paper or centrifuge in a microfuge at 13000 x g and use the filtrate or supernatant directly in the assay or with an appropriate dilution in distilled water (if required). The filtrate may be hazy but this is stable in the assay and contributes very little to the absorbance. Typically use a sample volume of 0.2 mL in Step 2 of PROCEDURE B.
 For analysis of results the dilution is 1 and the concentration of the prepared sample is 100 g/L (i.e. 1 g prepared in 10 mL).


Product Page (K-LACGAR)

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article